Starter Vape Kit OTD — for low budget

Choosing the core line

A starter vape kit programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.

We keep a short list of approved configurations for starter vape kits. Anything outside that list is possible, but it becomes a custom run with a custom lead time, and we quote it as such rather than pretending everything is standard.

We source starter vape kits from a small group of factories we have worked with for years. That means a specification can be held across repeat orders instead of being re-qualified from scratch every quarter. Consistency is a boring selling point and it is also the entire game.

Getting the carton there intact

Transit times move with the season. Book space early for Q4 and around Chinese New Year, when factory output pauses for two to three weeks and freight rates tighten at the same time.

We ship from Shenzhen and Guangzhou: air express for samples and part loads, sea freight for volume. Typical production lead time is 30 working days after artwork approval, plus transit. We quote both routes so you can see the trade-off instead of guessing at it.

Getting the documents right

If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.

Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.

• Cartons drop-tested and pallet-counted for clean freight
• Specification locked in writing before production starts
• Artwork proof plus physical dummy for custom packaging
• Batch codes traceable from carton back to production date
• Consolidated or split shipping, quoted both ways
• Standing reorder schedule with a fixed cut-off

Batch consistency and why it matters

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.

Specification summary

The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz