VapeWholesaleHub  |  Wholesale supplier · Shenzhen, China
Tel / WeChat / WhatsApp: +86 13711127975  |  vape@0099933.xyz
Home  /  Starter Vape Kit  /  Choosing Starter Vape Kit PO terms 2027
starter vape kits · distributors

Choosing Starter Vape Kit PO terms 2027

We work with distributors who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.

Published 09 April 2026  ·  VapeWholesaleHub  ·  Reading time 6 min

Bulk packing station during the run for a distributors order.
Bulk packing station during the run for a distributors order.
Surface finish under raking light, one of the cosmetic checks.
Surface finish under raking light, one of the cosmetic checks.
Close inspection of the assembly line before the batch is released.
Close inspection of the assembly line before the batch is released.

Compliance without the last-minute scramble

If you are comparing three quotes for starter vape kit, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.

If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.

Regulation for starter vape kits differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.

Reading a quotation properly

Currency moves more than most buyers expect over a twelve month supply plan. We quote in USD and hold the price for 30 days from confirmation so your margin calculation is not guesswork.

We publish a realistic band of 2.74 to 8.78 per unit for standard configurations at 100 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.

For distributors, the practical answer is usually a shorter range: two core lines, one step-up, one trial SKU. Everything else is inventory risk wearing a nice finish.

Building an assortment that actually turns

A practical starting order for distributors is 100 units across two or three SKUs, not 100 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.

Colour range is where assortments quietly die. Six finishes look impressive in a brochure and disastrous on a shelf with 40 cm of space. We recommend two finishes per core SKU and let the trial line carry the novelty.

  • Document pack prepared per destination market
  • Reference sample retained from every batch
  • Cartons drop-tested and pallet-counted for clean freight
  • Specification locked in writing before production starts
  • Consolidated or split shipping, quoted both ways
  • Mixed SKU cartons to spread first-order risk

After-sales, replacements and reorders

The replacement policy is deliberately simple: report within seven days of delivery with photos and the batch code, and we replace or credit at the next shipment. We do not argue about a defect we can see in a photograph.

Technical questions usually arrive at the worst possible moment, which is why we answer them on WhatsApp as well as email. A photo and a two line message resolves most issues faster than a ticket.

Specification summary

Typical specification for this category
Battery500 mAh
Pod capacity3.0 ml
Coil resistance1.2 ohm
IncludedDevice, 2 pods, cable
ChargingUSB-C 5V/1A
PackagingBlister pack
Minimum order100 units per SKU, mixed cartons allowed
Lead time22 working days after artwork approval

The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.

Frequently asked

Can we order samples before committing?

Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 100 units. We would rather you handle the sample than approve a specification from a photograph.

What documents come with a shipment?

Commercial invoice, packing list, and the certificate pack for your market: test reports, declaration of conformity and safety data sheets. We send scans before dispatch so your broker can pre-clear the file.

What is the minimum order for starter vape kit?

Standard configurations start at 100 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 300 units because of setup time on the line.

Related reading

Need a quotation on starter vape kits?

Send destination market, target price and quantity. Same-day reply on working days.

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz

Talk to the supply team

Ask for a quotation on starter vape kits

Tell us the market you sell into and the price band you work in. You will get a specification and a landed cost estimate, not a catalogue dump.

What to send

Destination market, target retail price, quantity per SKU, and whether you need private label. With those four lines we can quote the same day.

Samples ship by air express and the cost is credited against your first production order.

Email the team
WhatsApp Email us